With a cost-effective IDE/SATA2 approach, the SR2600 mirrors data to two hard IDE/SATA2 drives simultaneously, and delivers optimized performance compared to costly SCSI solution. If one drive fails the second drive immediately and automatically takes over and system will continue the operation transparently. In case of drive failure, high temperature in the unit and on the drives and a fan failure, the alarm ( internal buzzer) will sound and an email will be sent through the GUI RAID Management Software to inform you about the nature of failure (drive, fan or temperature).

Featuring intelligent on-line recovery, the SR2600 provides complete protection for system data. You can hot swap a failed drive without any interruption and the SR2600 will rebuild the data automatically to the new drive without any data loss.

SR2600 is a standalone HDD duplicator and can work without connecting to the PC IDE/SATA port. It can duplicate source hard disk into the target drive independently by only connecting a 4-pin power cord.

SR2600 saves daily backup time and it can save all the files into dual independent hard disks.  Users don't need to make daily backup routines.  Just replace a drive and the duplication starts automatically without any system shut-down.

20" ~ 50cm long internal ribbon cable with IDC 2x5 female connector for internal COM1/2 port on motherboard-to-Molex 3pin female connector for back of SR2600 unit to offer RS232 port for the GUI Software.